Course Outcome

5 Modules

Module 1 – An Overview of Bearings & Bearing Maintenance

At the end of this module the learners will be able to:

• Recognise and describe the commonly used bearings
• Describe the general principles of maintenance on bearings
• Perform a simple procedure checking running bearings using basic equipment

Module 2 – Plain Bearings (Bushings)

At the end of this module learners will be able to:

• Remove and replace plain bushings using a screw-thread puller and a hydraulic press
• Remove and replace automotive shell type bearings
• Check running clearance

Module 3 – Removal & Replacement of Anti-friction Bearings

At the end of this module learners will be able to:

• Demonstrate the removal and replacement procedures of single race ball or roller type bearings

Module 4 – Servicing

At the end of this module learners will be able to:

• Demonstrate ability to replace a set of taper roller bearings in a wheel hub
• Adjust tolerances using a typical procedure

Module 5 – Bearing Fault Diagnosis

At the end of this module learners will be able to:

• Identify common bearing faults by analysing certain wear or damage patterns